I have a question that I'm pretty sure I know the answer to.
When I match drilled the trim pushrod I was off a little which caused the rivet not to sit perfectly square. As you can see in the pic it caused the rivet to fold. When I went to set the 2nd rivet it started to do the same so I stopped. What would you recommend?
When I match drilled the trim pushrod I was off a little which caused the rivet not to sit perfectly square. As you can see in the pic it caused the rivet to fold. When I went to set the 2nd rivet it started to do the same so I stopped. What would you recommend?