View Single Post
  #14  
Old 09-05-2021, 07:50 AM
JDA_BTR JDA_BTR is online now
 
Join Date: Dec 2013
Location: Colorado Springs, CO
Posts: 1,361
Default

I'm pretty good at Molex connectors, but even I succumbed to the pins/heatshink solution. After I built my panel I had lots of pins and heatshrink, and the right crimper. So it is dead simple to just connect each wire with a pin set and little heatshrink then heatshrink the bundle. Completely reliable, unlike the Molex. If you do need to remove it then you just cut off the heatshrink and the pins come apart.

I've left the Molex that work alone, but both of them for the elevator trim have been abandoned.
__________________
Ser 140142, RV-14A flying - N1463
Ser 83825, RV-8 building - N8638?
USN Ret, Urologist, AME, Repeat Offender
Reply With Quote