View Single Post
  #1  
Old 10-08-2021, 07:13 PM
jrock836's Avatar
jrock836 jrock836 is offline
 
Join Date: Nov 2020
Location: Burleson, Texas
Posts: 329
Default Trim Indicator Not Indicating

I'm try to troubleshoot why my trim indication isn't working. It stays planted at the bottom of the display. The servo still works. I have looked at all of the connections and plugged in / unplugged all three of the wires responsible for indicating the position of the trim servo and everything seems clean and secure. My trim servo is the Ray Allen ES MSTS-T3-7A-2 unit.

I do show 5 volts on white/blue wire coming from the EFIS.
As I understand it the two white wires 31/32 is just switched power to the servo to make it move each way. If that's the case, the only other wires to be concerned with would be the whi/grn (4) position wire and whi/orange (25) grnd wire. The (25) ground wire does show continuity to ground. Not sure how I should test the position (4) white/green wire.. Is there a voltage out of the servo I should be looking for? I'm showing about 1.4 volts which will vary as I move the trim up and dow..

Edit.. Nevermind.. I figured out the problem..

Apparently somewhere between the tail and the front fuselage harness, the grn/whi #4 wire is broken.. No continuity.. ugggg...
Attached Thumbnails
Click image for larger version

Name:	20211008_192029.jpg
Views:	44
Size:	297.5 KB
ID:	16895  Click image for larger version

Name:	20211008_192823.jpg
Views:	42
Size:	187.4 KB
ID:	16896  Click image for larger version

Name:	20211008_192835.jpg
Views:	41
Size:	282.7 KB
ID:	16897  
__________________
Joe
Van's RV-12 #120566 - ELSA - N49DD
Spinks Airport, KFWS, Fort Worth, TEXAS!


DONATED

Last edited by jrock836 : 10-08-2021 at 09:42 PM.