View Single Post
  #7  
Old 10-06-2021, 06:06 AM
peter houpt peter houpt is offline
 
Join Date: May 2021
Location: zwolle , the Netherlands
Posts: 5
Default stabilator fairings

I do not think so. In step 4, page 12A-02, it tells:'' install ten rivets at the locations called out in Figure 3 on both top and bottom surfaces of the the stabilator, without installing the tip fairings''.
So the skin and ribs are already mated. The reason you see the the rib in the slit is because I made the holes in the rib too far to the outside.
Reply With Quote