Originally Posted by dwilson
I am going to move my RV10 fuselage from Kelso, WA to Sunriver, OR next week and am looking for a good way to use an auto trailer as you did.
Can you give a thumbnail sketch of how you adapted the trailer to the job?
Did you get/need any special permits?
You can see some shots of how Paul extended his trailer's width to accommodate the gear in my blog post (http://myrv10factory.wordpress.com/2.../the-big-move/
). This gave us 1" on each side of the mains to fit. We put a red shirt (Stein Air) that I had been using and was dirty - seemed a fitting use, as a marker for a long load.
Thanks Stein Air!! Your shirt not only works to assemble an airplane it can help move one too.