View Single Post
  #3  
Old 01-12-2021, 08:12 AM
iamtheari iamtheari is offline
 
Join Date: Nov 2017
Location: ND
Posts: 512
Default

The problem is that the plans seem to get the count wrong. On page 47-19 it says "4X DIMPLE #30 FLUSH THIS SIDE." On page 47-20 it says "5X AN426AD4-6." I'm trying to figure out if the diagram on page 47-19 should read "5X" or if there is a reason not to dimple the fifth hole at that point.
Reply With Quote