View Single Post
Old 01-18-2021, 07:23 AM
John-G John-G is offline
Join Date: Jan 2012
Location: Northeast Ohio
Posts: 752

I'm pretty sure my initial marking of the tail cone fitting was done with the tail feathers off. Then at some point they were installed because I do remember doing the drilling for the nutplate screw and rivet holes with the tail feathers on.

Sixth photo in this blog post:

Beginning with the third photo in this post:

Hope that helps .... happy building.

RV-12 Wings, Empennage, Fuselage, Finishing, Avionics and Powerplant kits all completed
Now Flying!!

Donation paid until September 2021
Reply With Quote