ERushing
Well Known Member
I'm getting ready to install the float fuel senders in my QB Wings. Has anyone else done this? Any suggestions?
Instructions state that the float needs a maximum clearance of 1/8" from top and bottom of tank. Also states that floats should be centered between the vent line and the aft upper tank stiffener. Unless I can figure out how to get a camera in there, I don't see how I can accomplish any of this except via blind luck.
Your suggestions would be very welcome. Thanks!
Instructions state that the float needs a maximum clearance of 1/8" from top and bottom of tank. Also states that floats should be centered between the vent line and the aft upper tank stiffener. Unless I can figure out how to get a camera in there, I don't see how I can accomplish any of this except via blind luck.
Your suggestions would be very welcome. Thanks!