bruceh
Well Known Member
I'm putting the main wheels on the gear legs. Looking at DWG C2, you can sort of see the picture of how these come together, but it is rather sparse on detail. I've got the powder coated U-403 bracket mounted to the gear leg, the brake mounting plate outside of that, then on the back side of the U-403 are the three U-408 spacers, and finally the U-810 wheel pant support bracket. The issue I'm having now is in the picture below (right gear leg shown).
The brake caliper should be able to slide into the two holes on the brake mounting plate, but the U-810 is slightly covering the top hole.
Anyone else run into this? I'm assuming I can just trim the U-810 so that the brake calipers have an unobstructed path into the guide holes.
The brake caliper should be able to slide into the two holes on the brake mounting plate, but the U-810 is slightly covering the top hole.
Anyone else run into this? I'm assuming I can just trim the U-810 so that the brake calipers have an unobstructed path into the guide holes.