I seem to be having a problem getting the flap position (indicator) to display properly using a VPX and G3X. Flap motor works fine. All of the trim servos work fine. I have rechecked every Tosten wire on the stick to make sure there is no loose ground or mal-placed wire. Using the VPX configurator the position does not change smoothly and near the top I momentarily peg out roll and elevator trim indicators on the PFD. Mechanically everything seems to work well just getting the indicator to display on the G3X properly or at least closley represent what's happening when the flaps are moving is my challenge....anyone else have this issue. Appreciate any thoughts if you've seen this before.