Vansrv7arob
Well Known Member
Hi Guys,
Thought I'd share some photos and progress updates as I move through this mod.
Im not going to share all the details as they can be found on the G3I website.http://www.g3ignition.com/magmod.html
Photo of G3i control box mounting, yes the zip ties will be replaced by p-clamps...
The first thing to do is remove the old ignition leads.
Then drill out the holes to size to suit tap easy on a bench drill.
I found the best way to mount the mag caps was to screw them to a bench top.
Lots of boelube, the trick to a good tap is start slowly and carefully to get the tap started and straight. Then about 1/8 to 1/4 turn and then back off 1/2 turn to break chips, rinse and repeat until your through.
I'll post further updates as i move through the process.
Thought I'd share some photos and progress updates as I move through this mod.
Im not going to share all the details as they can be found on the G3I website.http://www.g3ignition.com/magmod.html
Photo of G3i control box mounting, yes the zip ties will be replaced by p-clamps...
The first thing to do is remove the old ignition leads.
Then drill out the holes to size to suit tap easy on a bench drill.
I found the best way to mount the mag caps was to screw them to a bench top.
Lots of boelube, the trick to a good tap is start slowly and carefully to get the tap started and straight. Then about 1/8 to 1/4 turn and then back off 1/2 turn to break chips, rinse and repeat until your through.
I'll post further updates as i move through the process.