VAF Forums

VAF Forums (https://vansairforce.net/community/index.php)
-   Autopilots (https://vansairforce.net/community/forumdisplay.php?f=37)
-   -   Trutrak flat pack cutout (https://vansairforce.net/community/showthread.php?t=43006)

vmirv8bldr 05-03-2009 10:29 AM

Trutrak flat pack cutout
 
I had my panel cut, but the about half the holes need to be enlarged a fair amount. I went with a TruTrak AP, and selected the Flat Pack control head. However, to delay expense as much as possible, I don't physically have the head yet. So, does anyone have the dimensions for the cutout in the panel for a DGII Flat Pack? I looked all over TruTrak's website and didn't see it, and I searched here for quite a while to no avail.

If anyone has this head laying around and could measure for me, I would be grateful.

Thanks,
Bart

frazitl 05-03-2009 11:02 AM

I have mine at the hangar. Could measure for you, but be aware that the corners are cut off of the face plate. That is, the cutout is a rectangle with each corner cut about 1/2" or so. I think it would be very hard to do a decent cutout without the flatpack in hand.


Radomir 05-03-2009 11:04 AM

Send me your email address and I'll email it to you.. it's a PDF doc..

Mike S 05-03-2009 01:04 PM

contact the mfg.
 
TruTrack emailed it to me.

SteinAir 05-03-2009 09:56 PM

Hi Bart,

Drop me a line tomorrow of list and I'll send you a 100% drawing or a CAD file of it. Who cut your panel? You shouldn't need to mod the holes if the originating CAD file was good....(now if we cut it, call me a chew me out, because that shouldn't happen)! :) Our CNC usually will cut holes within a couple thou of what we tell it to.

Cheers,
Stein

Richard Connell 05-04-2009 05:10 AM

For Future ref: Trutrak Digiflight Flat Pack Cutout Dimensions
 


All times are GMT -6. The time now is 01:03 PM.