Well I'm off and running. Wishing I would've started at the vertical stab instead of the horizontal as others indicated. I have a question for the group of 7 builders.
On the front spar assembly when match drilling the holes for HS-702 and HS00001, there are two holes on each side that don't have a corresponding hole in the reinforcement angle HS-710 and HS-714. Should I drill these holes through the angle? Or are they just unused?
https://photos.app.goo.gl/ru3DW58ghTxZzdwT6
On the front spar assembly when match drilling the holes for HS-702 and HS00001, there are two holes on each side that don't have a corresponding hole in the reinforcement angle HS-710 and HS-714. Should I drill these holes through the angle? Or are they just unused?
https://photos.app.goo.gl/ru3DW58ghTxZzdwT6
Last edited: