roadrunner20
Well Known Member
I'm troubleshooting a starting problem with my EXP2 Bus using an external master relay setup. For those using it, can you reply with your setup
I think this may be the proper setup.
Can anyone verify this is correct? Or help with the setup.
From EXP2 Bus
ALT to Alternator output
BAT to Battery+
BAT to Master Relay "B" terminal
Square K1 pads jumped together with a #12 wire
P10 to the center lug of the master relay
J16 connected to J10
I think this may be the proper setup.
Can anyone verify this is correct? Or help with the setup.
From EXP2 Bus
ALT to Alternator output
BAT to Battery+
BAT to Master Relay "B" terminal
Square K1 pads jumped together with a #12 wire
P10 to the center lug of the master relay
J16 connected to J10
Last edited:
