jsharkey
Well Known Member
I just installed the headset mike/phone sockets in a pair of Radio Shack 3" x 2" x 1" ABS "project boxes" - less than $3 a piece - and mounted them at the rear of the armrests as shown below. Wires will run under the armrest and up through grommets into the boxes. Tough, insulated, light, cheap, look neat and will protect the connections. Hopefully the position will be convenient too. I had to drill a few holes and remove some internal PC board mounting details from inside the boxes with a sharp chisel.
Jim Sharkey
RV6 - Wiring
Jim Sharkey
RV6 - Wiring
Last edited: