I use the ON-ON-MOM locking toggles like these from Stein.I plan to eliminate the ACI switch and install two toggle switches for the mag/Surefly. What switches do you use. I would prefer locking toggles but open to suggestions. Also what do you use for the start switch When replacing the ACI. Thanks….
I did the exact same thing. ON-OFF-MOM for left and ON-OFF-MOM for right, and I hold both in the full up position to start. Switch was Carling 6GM5E-73. So far so good as well.I wired my two mags like a starter as described by Mich48041 in post #10 of this thread.
https://vansairforce.net/threads/how-would-i-wire-2-mag-switches-like-a-starter.134260/
I used 2 DPDT switches and 1 "Engine Start" push button switch, all purchased from Stein. I wired them per Nuckoll's instructions.I plan to eliminate the ACI switch and install two toggle switches for the mag/Surefly. What switches do you use. I would prefer locking toggles but open to suggestions. Also what do you use for the start switch When replacing the ACI. Thanks….
I have used this set up on several planes and it works well for me.I plan to eliminate the ACI switch and install two toggle switches for the mag/Surefly. What switches do you use. I would prefer locking toggles but open to suggestions. Also what do you use for the start switch When replacing the ACI. Thanks….
Similar, but a momentary labeled around the switch.For those with the Aerosport carbon fiber panel; I'd bought the same red start switch and guard from Stein as Scott posted above. But I really wanted something labeled "Start" and I'm not a fan of the other style switch Stein sells.
A lot of the generic start switches online are labeled "Start/Stop." I wanted an OE quality switch only labeled "Start."
After some searching, I found this Start switch that was used on a variety of Can-Am products (Part# 710002594).
It fits the Aerosport panel like it was made for it.
View attachment 58983View attachment 58984