alpinelakespilot2000
Well Known Member
I'm not clear on the shielding requirements for my Flightcom 403 harness:
The flightcom installation manual indicates:
"• Use shielded wire for microphone, headphone, and audio wiring."
Of the 25 pins on the DSUB, which fit into this category? Am I looking for one of those 3 terms in the pinout name shown on the pinout chart below? If so, does that mean only wires 2, 3, 4, 9, 10, 11, 12, 14, 15, 16, 17, and 21 need shielding? Or, do some of the other pinouts require sheilding even though their names don't include those three terms?
http://www.flightcom.net/pdf/403-403dManual.pdf
Can anyone who's been through this let me know which pins need shielding?
Also, I assume that single conductor shielded wire is what I should use?
Thanks.
The flightcom installation manual indicates:
"• Use shielded wire for microphone, headphone, and audio wiring."
Of the 25 pins on the DSUB, which fit into this category? Am I looking for one of those 3 terms in the pinout name shown on the pinout chart below? If so, does that mean only wires 2, 3, 4, 9, 10, 11, 12, 14, 15, 16, 17, and 21 need shielding? Or, do some of the other pinouts require sheilding even though their names don't include those three terms?
http://www.flightcom.net/pdf/403-403dManual.pdf
Can anyone who's been through this let me know which pins need shielding?
Also, I assume that single conductor shielded wire is what I should use?
Thanks.
Last edited: