I’m setting up to MCS the trailing edge holes. I set the MCS on a piece of scrap metal to flush plus 7 clicks. When I MCK in the VA-140, the MCK meet when done from both sides. I’m using the Cleveland base to keep the MCS parallel to the surface. Is this normal?
Van's Air Force
Don't miss anything! Register now for full access to the definitive RV support community.
Trailing Edge MCS
- Thread starter BrianP
- Start date
Yes, it’s a thin piece, so the depth is at basically minimum. You’ll probably have one or two you overdo a bit and will get a slightly enlarged hole, so just be careful. Watch the end ones, where the countersink tool is not well supported on both sides.
