Davepar
Well Known Member
I'm getting ready to install the baffle air seals, and have a couple questions:
1. I'm planning on one piece along the back, one on each side, and one at the front. Should I be placing a seam along the sides where the baffles themselves come apart? Are other seams needed (especially along the front) in order for the seal to fold over properly?
2. I read somewhere that 2" above the baffle wall is a good starting place. Is 1" below good enough for attaching them?
3. I'm planning on using the standard Vans baffle seal material and standard pop rivets. I guess some people aren't happy with the puckering around the rivets. Are there any tricks for reducing that?
Thanks,
Dave
1. I'm planning on one piece along the back, one on each side, and one at the front. Should I be placing a seam along the sides where the baffles themselves come apart? Are other seams needed (especially along the front) in order for the seal to fold over properly?
2. I read somewhere that 2" above the baffle wall is a good starting place. Is 1" below good enough for attaching them?
3. I'm planning on using the standard Vans baffle seal material and standard pop rivets. I guess some people aren't happy with the puckering around the rivets. Are there any tricks for reducing that?
Thanks,
Dave