While measuring the fuselage width for the 42 5/32 dimension, I assume that is at station 56 13/16. (from dwg 39, 40) Well, mine seems to be wider by about 3/8 at that very point. I have enough width on the frame, just noticed most have to cut it down. Is this something to be concerned about, or is the plexi just going to conform to the correct width as I trim it.. Does that dimension (42 5/32) have to be maintained? Can the roll bar be move aft a little from the 56 station?
Thanks
Ron
9A Canopy
Thanks
Ron
9A Canopy