pierre smith said:
I'm assuming that the 9A manual also spells out how to align the stab by measuring from the tips to the center of the fuselage near the cabin, before drilling the attachment holes. The fin may or may not be perfectly vertical if you don't level the airplane left to right before drilling those holes either.
Just because I've just gone through this, I'm interested in the different ways the -9 manual says to do it, Pierre. They do seem to be pretty close to the -6, but a little different...
1. The manual says to measure from HS tips to the forward corners of the firewall, not the center, although the center would work just as well, of course.
2. Interestingly, nothing in the manaul says to have the fuselage level when you put the HS on. I guess it is assuming that you built your HS accurately, and that the aft deck is already twist free relative to the rest of the fuselage. (Maybe this was harder to do with the non-punched 6). For the -9, you just sit the HS onto the aft deck (on the 1/8" shims) and put a 11/32 drill bit under the rear spar to set the 0-degree incidence. At this point, the HS should be level relative to the fuselage. Mine did down to the 0.0 degree--Van's kit is amazing in this regard! Like you said, though, I think it is a good idea, to make sure your HS is level relative to the rest of the fuselage. My fuse. wasn't level during this process, but I made sure a digital level read the same on the firewall, seat back bulkhead, aft deck, and on the forward spar of the HS.
3. Re: the vertical stabilizer, once the HS is on, we just measure from the top down to the outboard edges of the HS. This will square the VS to the HS. Although Van's doesn't mention where to measure this, it really does have to be from the top at the rear spar since the leading edge of the VS is offset to the left (about 7/16, it seems). Assuming that you've set your HS level relative to the fuse., again the fuse. itself does not have to be level to make this measurement.
Again, just interesting to note the differences in the manuals for the various models. I wish Van's had been better about the empennage attach part (especially the VS) in the manual, but I figured it out in the end after looking a lot of builders' websites.
Regarding leaving them on, Paul. I'd love to because they really look neat up there, but I think it probably depends on your building space and whether or not you want to have to duck around or under them for the rest of the build. Mine will probably be coming off in the next few days after I get the rudder stops finished.