tonyjohnson
Well Known Member
I am about to rivet the end fittings on 3 of my pushrods, including the large one from the bellcrank to the elevator. Before I close it up, I thought I would ask here for advise regarding corrosion protection for the inside of the rods, which will not see the light of day again.
I read somewhere, in the plans I think, that Vans recommended primer for the interior of some of the pushrods.
What are the rest of you guys doing, if anything, to protect the inside of the pushrods from corrosion?
I read somewhere, in the plans I think, that Vans recommended primer for the interior of some of the pushrods.
What are the rest of you guys doing, if anything, to protect the inside of the pushrods from corrosion?