1. I squeezed my first rivets this week on the VS rear spar. Sometimes, when I check the squeezed rivet, the shop head diameter is right on, but the height may be a little too much. Since I'm using the rivet called out in the plan, I'm thinking this is OK. Am I doing something wrong?
2. After drilling out a bad AN470, I found myself with an slightly enlarged and elongated hole. Can I use the same size rivet again or must I use something else?
Getting ready to rivet VS skin to skeleton this weekend!
2. After drilling out a bad AN470, I found myself with an slightly enlarged and elongated hole. Can I use the same size rivet again or must I use something else?
Getting ready to rivet VS skin to skeleton this weekend!