Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

S
Reaction score
4

Latest activity Postings About

    • S
      ShawnR replied to the thread Basic Panel Installation Question.
      Sorry I cannot answer this. I made a new panel from the old one, using it as a template. But since the canopy sits on the top of the...
    • S
      I have those pedals. The floor panel is out for painting right now but I can throw it back in for a photo. It was only last year that...
      • 20240221_124848.jpg
    • S
      ShawnR replied to the thread Basic Panel Installation Question.
      My panel is in and out right now as I am at that point.I can take some photos shortly. As to the "carrying the load", I would venture...
      • 20240221_124633.jpg
    • S
      ShawnR replied to the thread Shawn's -4 re-build.
      I think that is the answer! Thanks for pointing that option out. I had not considered that one but will make the task at the airport...
    • S
      ShawnR reacted to PaulvS's post in the thread Shawn's -4 re-build with Like Like.
      Hi Shawn The location of your flyleds controller presents another option, which is to use a crimp Dsub connector at the controller...
    • S
      ShawnR replied to the thread Shawn's -4 re-build.
      Thanks Mike. Yes, I have been trying to label them all. I had a label maker so I am using it and putting clear heat shrink over it. It...
      • Wire label.jpg
    • S
      ShawnR replied to the thread Shawn's -4 re-build.
      Thanks Paul. I would rather not be doing those connections to the controller board at the airport, but you make good points. I don't...
      • Wiring in progress.jpg
    • S
      ShawnR replied to the thread Shawn's -4 re-build.
      I have been moving along with the wiring. Which prompts a question.... The wiring to the strobes in the wings is a shielded wire. To...
    • S
      I have a weeping rivet in one fuel tank as well, so this thread caught my eye. Kitplanes had an article earlier in 2023 that interested...
    • S
      ShawnR reacted to uk_figs's post in the thread Avionics Communications questions with Like Like.
      You can daisy chain the RS232 from the aera 660 to up to 5 devices, the "Aviation In/NMEA & VHF Out" is the most common selection as...
    • S
      ShawnR replied to the thread Shawn's -4 re-build.
      Thanks guys. Yes, there are 2 j-channel stiffeners underneath. And with the front edge being screwed to the bulkhead, I think it is...
      • Electrical shelf3.jpg
      • Electrical shelf2.jpg
    • S
      ShawnR replied to the thread Avionics Communications questions.
      Thanks. I only have the Aera660 manual (limited info as it is a portable) but can take a look at a friends again. Perhaps I can find one...
    • S
      ShawnR replied to the thread Avionics Communications questions.
      Thanks. I sent off an email earlier this morning to JPI asking for clarification again, as suggested. I also sent them my proposed...
    • S
      RS232 does need shielding. Whatever wire you are connecting and splicing into must be shielded. You should leave no more than about...
    • S
      ShawnR reacted to GalinHdz's post in the thread Avionics Communications questions with Like Like.
      After you have properly connected them together, set your GPS to "NMEA OUT" and see if it works. If you need the GPS data at the EDM350...
  • Loading…
  • Loading…
Back
Top