I'm finishing up the last few holes on the right side horizontal stablizer using the DRDT-2 dimpler. I guess when I was giving it a good push, it jumped the hole and made a new hole. ****!.
____, __________,_____________,_________ <---insert string of favorite cuss words there.
We all know that holding the folded skin, lining up the hole, and giving it a good push with the lever is awkward when we get up close to the folded half. And there it goes....
So the common question. Is a double hole like this (not an easier figure "8") something that can be worked around or is this a new skin?
This hole is in the middle of the stablizer.
I'm thinking it's time to contact Van's....unless someone has a good idea for this common problem?
Thanks,
Tom
Learning from mistakes.
____, __________,_____________,_________ <---insert string of favorite cuss words there.
We all know that holding the folded skin, lining up the hole, and giving it a good push with the lever is awkward when we get up close to the folded half. And there it goes....
So the common question. Is a double hole like this (not an easier figure "8") something that can be worked around or is this a new skin?
This hole is in the middle of the stablizer.
I'm thinking it's time to contact Van's....unless someone has a good idea for this common problem?
Thanks,
Tom
Learning from mistakes.