[thomaswimmer]

Hi,

I'm currently putting a nylon wiring conduit (the corrugated one) into my wing. I need to branch off some wires off the conduit. How do you guys do the y junction?
Just a hole and get the wires out?
Glueing a second conduit to the primary one?


Thanks

Thomas

 

[lorne green]

A 3/4" PVC tee worked well for me. Just drill and safetie the PVC fiting to the corrugated conduit so that it does't move.

 

[alpinelakespilot2000]

Just cut a hole in the corrugated tubing then use some shrink wrap, RTV, and/or UHMW tape where the wire comes through the hole. No need to get complicated here, but just my opinion.

 

[airguy]

Had to do that in my wing for the autopilot servo wires, I hardmounted the conduit to a rib, cut a small slit in the conduit, fished out the appropriate wires, left about an inch of slack and hardmounted them to the rib also on a separate mount before running them to the servo.

 

[rleffler]

Just cut a hole in the corrugated tubing then use some shrink wrap, RTV, and/or UHMW tape where the wire comes through the hole. No need to get complicated here, but just my opinion.

Mine is just how Steve described.....

bob