dick seiders
Well Known Member
It is near impossible to get total clearance between the two wire bundles when routing thru the adel clamps and over the rudder pedal support tubes. I used larger adels and flattened them. I also positioned them with the bolt hole inboard to avoid conflict with the center mounting block.Wires still lay on the tubes. Has anyone dropped the pedal assembly down about 1/8 or so using shims and relieving the opening a bit on the center console sides to allow the tubes to drop the 1/8? The rubbing action on the wires may only be slight, but will likely be a problem one day at a most inopportune time.
What have some of you done to resolve this issue?
Thanks.
Dick Seiders
What have some of you done to resolve this issue?
Thanks.
Dick Seiders