M MDeCraene13 Member Jan 11, 2021 #1 I was flipping through my wing build instructions and did not see a section on the control bell crank and pushrods. Did I miss it somewhere?
I was flipping through my wing build instructions and did not see a section on the control bell crank and pushrods. Did I miss it somewhere?
PhatRV Well Known Member Patron Jan 11, 2021 #2 I remember building two control rods and a bellcrank for each wing. I knew followed the plan when I was building them
I remember building two control rods and a bellcrank for each wing. I knew followed the plan when I was building them
bjdecker Well Known Member Ambassador Jan 11, 2021 #3 DWG 15A DWG 15A contains the dimensions, parts for the torque tubes and bellcrank installed in the RV 7/8 wings. Attached Attachments Screen Shot 2021-01-11 at 11.59.32 AM.png 79.8 KB · Views: 100 Screen Shot 2021-01-11 at 11.59.42 AM.png 106.7 KB · Views: 89
DWG 15A DWG 15A contains the dimensions, parts for the torque tubes and bellcrank installed in the RV 7/8 wings. Attached
M MDeCraene13 Member Jan 11, 2021 #4 Yeah, the parts are on Drawing 15A. I was just curious if there was a corresponding section in the build manual. I can build to the drawings if I need to.
Yeah, the parts are on Drawing 15A. I was just curious if there was a corresponding section in the build manual. I can build to the drawings if I need to.
PhatRV Well Known Member Patron Jan 11, 2021 #5 A couple lines of instructions here: Attachments Capture.JPG 121.8 KB · Views: 145