Louavul
Well Known Member
I'm nearing wing mate and drilling of the rear spar. The plans say to use a level and a "block" at the rear spar to get the 1 degree angle of incidence per drawing 38.
I've examined drawing 38 and find mention of the "block" but no measurements to fab the thing.
Is the "block" somewhere in the parts, already made, or do I craft it out of something to dimensions I don't seem able to find?
Thanks,
Steven L Hild
Belen, NM
RV-7 FUS
I've examined drawing 38 and find mention of the "block" but no measurements to fab the thing.
Is the "block" somewhere in the parts, already made, or do I craft it out of something to dimensions I don't seem able to find?
Thanks,
Steven L Hild
Belen, NM
RV-7 FUS