philcam

philcam

Well Known Member
What pop rivet would be used to replace a AN470AD4-4 and 4-6 rivet? I'm finishing my VS and am trying to figure out which pop rivets to use to attach the VS-707 to the VS-803PP.

Thanks!
 
For the three rivets that hole the middle rib to the rear spar? The rivet call out is LP4-3 for all three. Its on DWG 6.
 
I thought I was going crazy!

G-Force,

Thanks, I went to the garage and looked on DWG 6..... and looked...... and looked a while more, I didn't see it! I thought I was going crazy! So I came inside with the idea of scaning my smaller DWG 6 from the preview plans to email you and ask you where it says LP4-3.... and there it was! My kit and preview plans were purchased together, I don't know why my large DWG 6 doesn't have it printed on there.

At any rate, THANK YOU!

Phil
 
Thats wierd. My large drawing 6 is dated 4/9/01 and is the same as my 2004 and 2006 dated preview plans. Is your big drawing pre 2001?
 
Dates

My drawing show a "drawn on" date of 3/96. There are also four revisions, the last one dated 3/01.

My kit is the new style, all prepunched kit. Ordered 3/07...... hmmmm....

Phil
 
You must log in or register to reply here.