IowaRV9Dreamer
Well Known Member
I am about to start my Proseal adventure and have a question. I plan to use the tank dies on the rib rivets, and put a bit of PS into the hole before each rivet.
What about the stiffeners? I was planning on backriveting them and would ideally pre-load them all into the skin dry, then putting a "wet" stiffener on from the inside. In this case, would I be better off with regular dimple dies since there probably won't be any Proseal in the dimple?
What did you experts do? Thanks,
What about the stiffeners? I was planning on backriveting them and would ideally pre-load them all into the skin dry, then putting a "wet" stiffener on from the inside. In this case, would I be better off with regular dimple dies since there probably won't be any Proseal in the dimple?
What did you experts do? Thanks,