Working on an RV7A...
I have the interior painted, canopy fit and screwed to the frame, controls, fuel lines, rudder pedals, etc., complete, flap actuators assembled, etc. Everything is currently removed so I could paint the interior.
I need shelf space back and want to make progress, but I don't want to build myself into a corner, though I'm still able to work upside down under a panel without too much trouble. In what order would you do the following?:
Thanks for your advice! The instructions are becoming vague suggestions at this point, so your wisdom really helps.
I have the interior painted, canopy fit and screwed to the frame, controls, fuel lines, rudder pedals, etc., complete, flap actuators assembled, etc. Everything is currently removed so I could paint the interior.
I need shelf space back and want to make progress, but I don't want to build myself into a corner, though I'm still able to work upside down under a panel without too much trouble. In what order would you do the following?:
- Rivet tailcone skins to longerons
- Rivet side skins to longerons
- Rivet canopy side rails to longerons
- Rivet bulkhead and roll-bar (tip-up)
- Rivet in panel sub-assembly
Thanks for your advice! The instructions are becoming vague suggestions at this point, so your wisdom really helps.