I had to reach for the countersink cage today and couldn't remember if it was set for rivet depth or minus 7 clicks. Argh, I hate to drill a few new holes in angle stock, deburr and test it out. I came up with the idea of using red and green electrical tape wrapped around the cs cage. Green for skin, red for watch out, it's deeper and set to -7 clicks. I realized I didn't have any colored electrical tape, so I went to the junk drawer and grabbed some bread twist ties.
If it doesn't have a twist tie on it, check it. I also had the idea of taking some thicker flat stock (don't have any on hand, though) and making something like a pegboard. One for #30 and one for #40. Drill all of the holes once, then just check your cs depth on one or two holes as you need them.
If it doesn't have a twist tie on it, check it. I also had the idea of taking some thicker flat stock (don't have any on hand, though) and making something like a pegboard. One for #30 and one for #40. Drill all of the holes once, then just check your cs depth on one or two holes as you need them.