I'm rebuilding a nose rib for the vertical stab and i'm a bit of a noob on aluminum selection.
The VS rib vans uses in the kit is .030 thick.
If I where to guess, I would say 6061.. T? T3 to T6 just sounds like a good
robot movie.
I'm looking for some advice on material selection as well as a fast source in the south west.
Thanks- Bill
The VS rib vans uses in the kit is .030 thick.
If I where to guess, I would say 6061.. T? T3 to T6 just sounds like a good
robot movie.
I'm looking for some advice on material selection as well as a fast source in the south west.
Thanks- Bill
Last edited: