kevinh
Well Known Member
Hi ya'll,
I've worked a fair amount on drone software & hardware and I'm kinda interested in experimenting with rolling my own roll servo (carefully/on-a-bench, with even more peer review before putting it in a plane).
I'm aware of the shear pin and arm which is added outside of the trutrak, dynon etc... servo. But I'm curious about the innards. Have any of ya'll ever looked inside? Is it a stock stepper motor (ideally - can you read the part number/vendor?) or do they actually include custom gearing inside? I'm less interested in their stepper motor controller (I'd be plopping in a CANBUS based stepper controller).
Kevin
I've worked a fair amount on drone software & hardware and I'm kinda interested in experimenting with rolling my own roll servo (carefully/on-a-bench, with even more peer review before putting it in a plane).
I'm aware of the shear pin and arm which is added outside of the trutrak, dynon etc... servo. But I'm curious about the innards. Have any of ya'll ever looked inside? Is it a stock stepper motor (ideally - can you read the part number/vendor?) or do they actually include custom gearing inside? I'm less interested in their stepper motor controller (I'd be plopping in a CANBUS based stepper controller).
Kevin