ConAgraPilot
Active Member
Ok I have searched without luck so I will put it out here amongst the group. I'm working on the tie-down block and will be bolting them to the spars soon. The plans call for AN3-7A bolt, AN960-10 washer, AN960-10L washer and AN365-1032 nut for the four places. My question is which side does the thin washer go? I assume one washer fro the bolt head and one for the nut side, but I can't find anything on the plans (i'm sure I'm missing it) that says what side. Does it matter? or is there a school of thought on this?
Thanks in advance!
Michael
Thanks in advance!
Michael
![photo.jpg](/community/proxy.php?image=http%3A%2F%2Fi673.photobucket.com%2Falbums%2Fvv91%2FConAgraPilot%2Fphoto.jpg&hash=108767f0ab3ac513d875877ca4a3615c)
Last edited: