I'm trying to get the VS skin clecoed on so i can match drill.
When I fit the VS-705 nose rib the pre punched holes in the skin do not match up (only half the hole is visable).
I can fit the VS-705 first, but then the VS-704 root rib holes do not line up.
I have tried cleco'ing the skin in a different order but still the same problem. I have a feeling that the aft flange on the VS-705 has been bent incorrectly. Here is a photo:
Although blury, you'll notice the aft flang (on the right) bend is further outboard then the upper and lower flange. I think this may prevent VS-705 from being in the slightly lower position it should be.
Has anyone else had this problem?
When I fit the VS-705 nose rib the pre punched holes in the skin do not match up (only half the hole is visable).
I can fit the VS-705 first, but then the VS-704 root rib holes do not line up.
I have tried cleco'ing the skin in a different order but still the same problem. I have a feeling that the aft flange on the VS-705 has been bent incorrectly. Here is a photo:
Although blury, you'll notice the aft flang (on the right) bend is further outboard then the upper and lower flange. I think this may prevent VS-705 from being in the slightly lower position it should be.
Has anyone else had this problem?
Last edited: