rapid_ascent
Well Known Member
Hi gang,
I have had some trouble with the flush rivets that attach the VS-410 to the Rear Spar. Specifically the rivets that are very near the bend in the hinge bracket. I now have all of them set, but I'm questioning whether I need to redo some of them. I'm afraid this falls into the category of if I do it again it may be worse. I've attached a couple of pics for comments from the more experienced builders. So the question is do I leave it as is or try to make them better.
Thanks in advance for any comments.
I have had some trouble with the flush rivets that attach the VS-410 to the Rear Spar. Specifically the rivets that are very near the bend in the hinge bracket. I now have all of them set, but I'm questioning whether I need to redo some of them. I'm afraid this falls into the category of if I do it again it may be worse. I've attached a couple of pics for comments from the more experienced builders. So the question is do I leave it as is or try to make them better.
Thanks in advance for any comments.