crewdog434
Active Member
NEED HELP!!! After a few phone calls to Klause (Lightspeed) and the fine folks at JPI, I realized my Dual Lightspeed II's won't work with my VisionMicro engine monitor. 
The E.I. output is 10 volts for the tach. The engine monitor requires 5 volts. Anyone have a fix for this problem? An alternative would be to use a tach generator off the tach drive. But, I'd rather not do that. I posted this question in the General Discussion forum, but didn't get many hits. Thought I'd try here as well. Thanks in advance.
__________________
The E.I. output is 10 volts for the tach. The engine monitor requires 5 volts. Anyone have a fix for this problem? An alternative would be to use a tach generator off the tach drive. But, I'd rather not do that. I posted this question in the General Discussion forum, but didn't get many hits. Thought I'd try here as well. Thanks in advance. __________________
