[docrick]

I'm ready right now to rivet on the rear spar on the 9a vert stab. The last sentence in the instructions tell me to make sure I provide for wiring runs for a light (if desired) before riveting the rear stab on.

I posed a question a month or so ago and folks said not to worry about ordering lights now. I guess I should have asked if I need to do anything about FUTURE lighting considerations.

HELP. Do I need to run any conduit or string before riveting on the rear spar? If so since I have no idea which lighting system I want, how should I provide for access for wiring?

Thanks

 

[skyfrog]

There's a thread somewhere on this topic

I ran into this problem a few weeks ago. I was thinking I'd add a camera on top of the VS someday, so I wanted to run wire. I "had" decided on Home Depot conduit and actually cut the piece for the job. However, the weight of the conduit was significant compared to the VS itself.

Instead, I elected to just use grommets. I placed a wire in there for a pull thru, but will probably replace that later.

See picture below:

http://img166.imageshack.us/img166/3861/dsc01082pg9.jpg