If this has already been discussed, my apologies. I'm planning to make full use of Vertical Power's Primary Power System (PPS) and Electronic Circuit breakers (VP-X). I'm installing the canopy now, so I'm not far off from installing the engine mount, and thinking ahead I want to make sure that I don't box myself into a corner later on when it comes time to install the PPS. There are four nutplates and a doubler that I already installed on the firewall for the solenoids, contactors and relays which the PPS replaces. Has anyone else used the PPS, and if so where did you mount it, and what did you have to do differently than what is in the plans for the traditional components? In other words, I need to know where to put it so I don't have interference issues later when installing the engine and nose gear, and did you have to plug any of the solenoid mounting bolt holes?