Lizard Lips
Active Member
I feel really stupid but I am at a total loss on how to install the Dynon SV-ADAHRS-200 using the wing mounting bracket provided in Van's wing kit. Clearly the -200 is supposed to slide into the bracket and be held in place by the clip?? but the bracket is only 2-3/4" deep and the ADAHRS is almost 5" deep when you include the 9-pin connector on the back. The -200 then fits so loosely in the mount that it is sure to bounce around all over the place.
I'm probably looking at this all wrong and the solution is probably embarrassingly simple but I am at my witt's end. Does anyone have any suggestions or, hopefully, any pictures of their installation?
Joe
Longview, Texas
RV-14-A Fuse ~80% Engine and prop mounted
Wings ? working on wiring and ADAHRS
Arion Lightning LS-1 Flying regularly
2019 Dues Paid
I'm probably looking at this all wrong and the solution is probably embarrassingly simple but I am at my witt's end. Does anyone have any suggestions or, hopefully, any pictures of their installation?
Joe
Longview, Texas
RV-14-A Fuse ~80% Engine and prop mounted
Wings ? working on wiring and ADAHRS
Arion Lightning LS-1 Flying regularly
2019 Dues Paid