[scard]

Here I am installing the ignition wires for my dual P-mags. The instructions have a note that these are unshielded wires and should be kept separated via a wire loom... Yeah, yeah, I understand why and how. My question is, are people really making sure the wires remain separated along their full length? It sure is a lot of work to make that happen. Not bundled in a clamp or at any point? I suspect that if I follow my plan to do this right, I might be the first to pour ~20hrs or so into running the ignition wires .

 

[RV6_flyer]

You can make your own as suggested in the manual or you can buy something like this.

http://www.msdignition.com/wire_5.htm

There are several differnt styles available that can be purchased on eBay or at the local auto parts store.

I like NEET and find no reason that one should not follow the manufacturers directions.

 

[Davepar]

I used some ignition wire separators from an auto parts store, and a few strategic adle clamps. Wasn't difficult at all. Routing the FWF wires does consume some time, though.