C crabandy Well Known Member Jan 9, 2013 #1 What's the best method to trim the outer sheath on the control able for the FAB alternate air/heater inlet door?
What's the best method to trim the outer sheath on the control able for the FAB alternate air/heater inlet door?
L lorne green Well Known Member Jan 9, 2013 #2 A thin zip disc mounted in your air die grinder. Plus a little care.
N Norman CYYJ Well Known Member Jan 9, 2013 #3 Pull the inner cable out first before making any cuts.
Dbro172 Well Known Member Jan 9, 2013 #4 Just did it bout an hour ago! Pull back (out) inner cable and cut coiled sheathing with pliers or dykes. (Or cable cutter, saw, die grinder Dremel)
Just did it bout an hour ago! Pull back (out) inner cable and cut coiled sheathing with pliers or dykes. (Or cable cutter, saw, die grinder Dremel)
G gasman Well Known Member Friend Jan 10, 2013 #5 Dykes make a good cut of the coil without making a taper like a disc cut off would. Then just de bur the end.
Dykes make a good cut of the coil without making a taper like a disc cut off would. Then just de bur the end.