I was flying today, and my Transponder (Dynon) went offline. When I got on the ground, I found that the 25 pin d-sub connector "XPDNR" had come disconnected (42CIS/U-02-Step 9). I reinserted the connector and snugged the screwed on the 25 pin, but concerned it might vibrate loose again. It is mounted on the inside of the firewall, and probably picking up vibratoins from the engine mounts. The airplane has about 90 hours on it. Should I apply any loctite or is there a better method to prevent this from coming loose?
Thanks in Advance,
Harry Burnette
N1022Y
Thanks in Advance,
Harry Burnette
N1022Y