Was looking for examples online of some set trailing rivet sets. Came across this picture-
http://www.aclog.com/rv-9a/images/Empennage/emp/DCP_1315.JPG
Looks like he chose to alternate shop heads on each rivet. My question is are the non-shop ends driven far enough? I ask because I did my elevator trailing edge's last night and they look really similar to that middle one.
If that's good then I'll call it a day, if not how do I best drive that rivet down without tearing up the edge... back rivet, mushroom, ect?
http://www.aclog.com/rv-9a/images/Empennage/emp/DCP_1315.JPG
Looks like he chose to alternate shop heads on each rivet. My question is are the non-shop ends driven far enough? I ask because I did my elevator trailing edge's last night and they look really similar to that middle one.
If that's good then I'll call it a day, if not how do I best drive that rivet down without tearing up the edge... back rivet, mushroom, ect?
Last edited: