Westerhuis
Active Member
Hello
I have an engine that runs rough on low RPM. I have 'excluded' it being a mag issue.
Whilst fault finding, I found that the nuts holding the inlet manifold fairly lose. So I wonder if that is causing a bit of an air leak.
Does anyone happen to know what the correct torque setting would be with a rubberised / silicone gasket? See image.
Thanks
Roger
I have an engine that runs rough on low RPM. I have 'excluded' it being a mag issue.
Whilst fault finding, I found that the nuts holding the inlet manifold fairly lose. So I wonder if that is causing a bit of an air leak.
Does anyone happen to know what the correct torque setting would be with a rubberised / silicone gasket? See image.
Thanks
Roger