Who has come up with a good way to keep the spring of the side handle mechanism from riding up on top of the C-609 canopy latch? I know there are mods I could buy to replace the entire standard setup, but I don't see any reason to do that. The spring is the only part I'd like to deal with, since when it jumps up on top of 609, it binds and makes the mechanism sticky to operate. There needs to be a bigger bumper on the front of 609, but that's easier said than done since the wire has an arc path and can't just go through a simple hole. I may try 3D printing something, but not sure I can mount anything solidly enough to 609.