I'm currently working on the frame and have come to an issue I'm not sure of the best resolution.
When I fit the WD-725 side rails to the WD-716 frame, I have a gap between the rail ends and the 631 ribs of about 1/8". I have reviewed several builders sites and found indications this is not uncommon. There seems to be two solutions.
1. Leave a space between the 716 and 725 where the 613 join plate is rivetted. (Butt the 725s to the 631 ribs)
2. Use a spacer between the 725 and the 631. (butt the 725s to the 716)
I would be interested feedback on the pros and cons of each solution. Thanks
When I fit the WD-725 side rails to the WD-716 frame, I have a gap between the rail ends and the 631 ribs of about 1/8". I have reviewed several builders sites and found indications this is not uncommon. There seems to be two solutions.
1. Leave a space between the 716 and 725 where the 613 join plate is rivetted. (Butt the 725s to the 631 ribs)
2. Use a spacer between the 725 and the 631. (butt the 725s to the 716)
I would be interested feedback on the pros and cons of each solution. Thanks