BillL
Well Known Member
Hello All, I am building a 7 -tip up and have reached the canopy fitting stage prior to the "big cut". I have looked everywhere (it seems that way) but can not get a clear picture of where the cut on the front of the canopy will end as it meets the canopy skin.
1. Is it at the tangent to the radius where the canopy is parallel to the skin, in the middle, or the tangent to the radius at the top? in other words, will the plexi sit on the skin with a crisp angle, or will the formed transistion radius of the plexi remain? I have still about 1" over the roll bar, and want to get it fitted to the canopy skin before I mark for the big cut.
2. After addressing question 1 I need to understand fore and aft positioning, so, where is the 1.75" measured? at the projected intersection of the plexi to the skin? Or somewhere else?
Thanks in advance,
Bill
1. Is it at the tangent to the radius where the canopy is parallel to the skin, in the middle, or the tangent to the radius at the top? in other words, will the plexi sit on the skin with a crisp angle, or will the formed transistion radius of the plexi remain? I have still about 1" over the roll bar, and want to get it fitted to the canopy skin before I mark for the big cut.
2. After addressing question 1 I need to understand fore and aft positioning, so, where is the 1.75" measured? at the projected intersection of the plexi to the skin? Or somewhere else?
Thanks in advance,
Bill